What Are The 4 Terminals On A Golf Cart Motor?

If you’re unsure if it is working, it is simple to test. There are four terminals on a solenoid: usually two large and two small. The small terminals are connected to the battery, and the large terminals are connected to the motor. Disconnect all wires from the two large terminals.

  • Terminals are A1, A2, F1 and F2. I have continuity between A1 and A2 and between F1 and F2. I don’t have continuity between A1/A2 to the motor body but I do have 7.42 ohms from F1.F2 to the motor body.

What does A1 A2 S1 and S2 mean on a golf cart motor?

Series motors are almost always marked A1,A2 and S1, S2 S stands for stater and that is the stationary windings of the motor. Sepex or Separately excited motors are almost always marked A1, A2 and F1, F2 The F stands for field and that also is the stationary windings in the motor.

Where is the reset button on a golf cart motor?

First, you’ll want to reset your motor. Get out your handy screw driver and work to uncover the motor itself. It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor.

How is a electric golf cart Wired?

Technically, most electric golf cart battery banks use series wiring. The 36-volts club car golf cart wiring requires a set of six batteries of 6 volts capacity each. You will also need five equal size connection cables.

What is S1 and S2 on DC motor?

DC motor terminal leads are labeled for easy identification in the motor’s terminal box. For example, leads labeled “A1” and “A2” are connected to the armature through the motor’s brushes; leads labeled “S1” and “S2” are the ends of the series field; and leads labeled “F1” and “F2” are the ends of the shunt field.

See also:  How Many Golf Clubs In A Bag Uk?

Do all electric golf cart motors have a reset button?

Locate the motor Remove the panel so the electric motor is visible. Electric motors usually include reset buttons that can perform similar to circuit breakers. Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button.

Do all golf cart motors have a reset button?

Electric golf cart motors have a reset button on their chassis which is designed to put your motor back into its original factory state.

What happens when an electric motor burns out?

When a motor burns out, a short circuit occurs in the windings and the motor ceases to turn. You can test for a short circuit by checking the resistance of the windings with an ohmmeter; a reading of 0 ohms (Ω) indicates a short.

How do I know if my electric golf cart motor is bad?

You have enough going on in your life without your golf car refusing to start when you turn the key in the ignition. If your golf car won’t start, is slower than it used to be, or is experiencing other technical problems, you could have a bad motor on your hands.

How long does an electric golf cart motor last?

When properly taken care of, the typical gas or electric golf cart motor can last many, many years (20 to 30+). But the fact of the matter is, many people neglect taking proper care of their golf cart motor.

How do I know if my golf cart solenoid is bad?

Press on the accelerator while the key is turned on and the cart is in forward.

  1. The solenoid needs to be replaced IF the voltmeter shows a full battery voltage without a click.
  2. If your voltmeter stays at 0, the problem stems from somewhere else in your cart.

Leave a Reply

Your email address will not be published.