How To Tell If Electric Golf Cart Motor Is Bad?

You have enough going on in your life without your golf car refusing to start when you turn the key in the ignition. If your golf car won’t start, is slower than it used to be, or is experiencing other technical problems, you could have a bad motor on your hands.

How do I reset my electric golf cart motor?

First, you’ll want to reset your motor. It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again.

How long does an electric golf cart motor last?

When properly taken care of, the typical gas or electric golf cart motor can last many, many years (20 to 30+). But the fact of the matter is, many people neglect taking proper care of their golf cart motor.

What would cause an electric golf cart not to move?

Solenoid Wear When there is a disruption in the flow of the electrical current, your cart will not operate. A common reason for current disruption is solenoid wear. Each time the solenoid activates as you press down on the gas pedal, the solenoid compounds down onto a thin metal contact plate.

How do I know if my golf cart solenoid is bad?

Press on the accelerator while the key is turned on and the cart is in forward.

  1. The solenoid needs to be replaced IF the voltmeter shows a full battery voltage without a click.
  2. If your voltmeter stays at 0, the problem stems from somewhere else in your cart.
See also:  How To Learn How To Play Golf?

Do all golf cart motors have a reset button?

Electric golf cart motors have a reset button on their chassis which is designed to put your motor back into its original factory state.

What happens when an electric motor burns out?

When a motor burns out, a short circuit occurs in the windings and the motor ceases to turn. You can test for a short circuit by checking the resistance of the windings with an ohmmeter; a reading of 0 ohms (Ω) indicates a short.

What are the 4 terminals on a golf cart motor?

If you’re unsure if it is working, it is simple to test. There are four terminals on a solenoid: usually two large and two small. The small terminals are connected to the battery, and the large terminals are connected to the motor. Disconnect all wires from the two large terminals.
See also: What Are The 4 Terminals On A Golf Cart Motor?
Read More: What Are The 4 Terminals On A Golf Cart Motor? (Best solution)

Do golf carts have fuses?

Yes, golf carts contain fuses just like those found in a car or truck.

What is high mileage on a golf cart?

An average electric golf cart with a 48-volt system can go for 40 miles on a single charge up to 80 miles if driving through flat and level surfaces.

How do you troubleshoot an electric golf cart?

There are a few simple problems that you can fix yourself that will not necessitate professional maintenance.

  1. Test the wall socket where you charge your cart.
  2. Expose your golf cart batteries.
  3. Test the batteries for voltage.
  4. Replace dead batteries.
  5. Expose the motor for inspection.
  6. Reset the motor.
  7. Test the cart.
See also:  How Long To Wait To Use Golf Clubs After Regripping?

How do you know if your golf cart clutch is bad?

What Kinds of Problems Can a Golf Cart Clutch Have?

  1. A sudden inability to maintain even slow speeds when heading uphill or changing elevation.
  2. Slowing down to a crawl, then speeding up, then slowing again, seemingly without reason.
  3. Jolting during startup.
  4. A ‘cranking’ sound when starting up the golf cart.

Why does my electric golf cart hesitate when I accelerate?

Loose Connection Inspect the wires carefully and make sure all of them are correctly connected. Sometimes loose wiring can cause the speed controller to malfunction. You need to make sure that all the wires are plugged in tightly. Along with this, you also need to inspect the condition of the wires.

How do you fix a golf cart that won’t move?

Reconnect or tighten any wires on your MCOR connection which may have worked loose—doing so may be enough to get your cart to start turning over. Look for any damage to wires on your MCOR connection—this damage can occur over time and may cause your cart to fail to turn over. Replace any damaged components or wires.

Why won’t my golf cart go forward or backwards?

For example, if your run/tow switch has malfunctioned, your cart won’t go forward or backward. Check the switch to make sure that it isn’t “stuck” between the two modes. You may also need to hire a mechanic to replace the switch if it is wearing down and no longer operational.

Leave a Reply

Your email address will not be published.