How To Grease Ez Go Golf Cart?

  • Apply a light coat of grease to inner race and place inner wheel bearing in hub. Orient new grease seal so the flange side of the seal is facing into the bore. Tap gently into place until seal is flush with end of hub. How do I grease the pinion on my ezgo golf cart – Answered by a verified Electric Vehicle Mechanic.

Where are the grease fittings on EZ Go golf cart?

The front end of your car will have “Zerk” or “Grease Fittings”, that allow you to apply grease via a grease gun into the high wear points on the golf cart.

How much oil does an Easy Go golf cart take?

The oil capacity is 1 1/2 qts.

Why do golf carts wobble?

Wobbly Golf Cart Whenever You Drive Your cart may feel like it is going to fall apart and could experience some damage to its chassis as you ride. Poor tires are one of the most common causes of this problem. When your tires are not fully round, they are going to wobble a little and make your cart uneven.

How do you fix a squeaky golf cart?

The easiest way to fix this problem is to identify the springs which are squeaking and to apply a silicon lubricant to them. This type of spray is quite easy to apply and doesn’t cost a lot of money to purchase, which makes this a fairly easy repair.

How often should you change the oil in a golf cart?

If your golf cart is used often, you’ll want to check on it more than that. You’ll need to replace your engine oil and filter semi-annually, generally once it hits around 125 rounds or 600 miles of usage. For new engines, your initial oil change should be after 8 hours of run time.

See also:  What Are The Best Ladies Golf Shoes?

Should I leave my golf cart plugged in all the time?

A golf cart battery is supposed to charge and discharge and recharge again in that cycle while it last. Leaving your golf cart plugged all the time is not an ideal maintenance practice for the longevity of your battery. The minimum maintenance for a battery is recharging it soon after use; unplug it when fully charged.

Do wheel bearings need to be greased?

Not only should grease be packed into the bearing, but some grease should be applied to the housing and on the wheel end’s inside surfaces where the bearing sits. This will help prevent corrosion. The housing should also have some grease in the cavity surrounding the bearing, but it should not be filled.

Can you put too much grease in a wheel bearing?

Too much grease volume (overgreasing) in a bearing cavity will cause the rotating bearing elements to begin churning the grease, pushing it out of the way, resulting in energy loss and rising temperatures. This can result in accelerated wear of the rolling elements and then component failure.

Leave a Reply

Your email address will not be published.